LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Exterior Lights, Lamps, Switches - 911 CARRERA (996)) >> Removing and installing control module for gas discharge lamp >> Removal

Removing and installing control module for gas discharge lamp: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch off the light. Release the headlight housing and pull out forwards slightly.
  2. Disconnect the electrical plug connection of the automatic headlight beam adjustment and remove the headlight housing.
  3. Release and open the cover with control module. Disconnect the electrical plug connection from the control module and undo the three fastening screws.
    Fig 1: Removing Control Module For Gas Discharge Lamp & Undoing Fastening Screws
    G03063649Courtesy of PORSCHE OF NORTH AMERICA, INC.
  4. Remove the control module from the cover.
scientia non olet · About LEMON Manuals