LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 40 (Exterior Lights, Lamps, Switches - Diagnosis) >> System HBA 01 >> Checking the actual values >> Test point 5

Test point 5

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

ABS speed 

If 0 km/h is displayed when the wheel is rotated:

  1. Check fuse B9
  2. Switch ignition off and pull off plug on the control module
    • Switch ignition on
    • Rotate the rear left wheel by hand and measure the voltage (AC range) between terminal 11 and ground

      Voltmeter display greater than 1 V

If the wheel speed signal is present at the control module, replace the control module. If the wheel speed signal is not present at the control module, check the wire for open circuit or short to ground and check the ABS or PSM control module.