LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Turbo, Automatic >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring - 911 Turbo (996) >> Repair of rear wiring harness >> Removing rear wiring harness

Removing rear wiring harness

  1. Disconnect the battery and cover terminal or battery.
  2. Undo combination wire in the area of the rear wheel housing.
  3. Remove trim of seat well and cover of rear side member.
  4. Undo rubber grommet, unclip combination wire on inside and open wiring duct.
  5. Uncover combination wire in the interior as far as plug connection X 2/4 and disconnect plug connection (do not damage any other wires).
scientia non olet · About LEMON Manuals