Adjusting switch if pedal travel is too small: Notes
There are two possibilities to adjust the switch if the pedal travel to the switching point is too small.
1st possibility:
- Press the brake pedal and pull out the switch plunger.
- Release the pedal.
- Check adjustment.
2nd possibility:
NOTE:
- A play-free fit of the switch is no longer ensured after it has been installed and removed several times. The switch must be replaced by a new switch as soon as it perceptibly "wobbles" in its receiver.
- When installing the switch for the first time, it is essential to press it vertically against the bearing surface. It will otherwise not be possible to lock the switch (90° turn), even if great force is exerted.
- Release switch by turning it 90° and pull it out of the installation opening.
- Pull operating plunger out of the switch as far as it will go.
- Reinstall the switch.