Fault code 7: Diagnosis/Troubleshooting

Diagnosis/Troubleshooting (FAULT CODE) (1 Of 2)

Work instruction			Display OK	If not OK
1	Calibrate control module	Select menu item Calibration in the Porsche System Tester 2 Observe instructions on the screen Carry out calibration	"End"	"Continue with 2"

NOTE:

Calibration is not possible if the sensor voltage lies outside the plausible range (sensor voltage less than 2 V or greater than 3 V).

Diagnosis/Troubleshooting (FAULT CODE) (2 Of 2)

Work instruction			Display OK	If not OK
2	Check sensor voltages	Select menu item Actual Values in the Porsche System Tester 2 Vehicle on level surface (not raised)	2 - 3 V "End"	"Continue with 3"
3	Visual inspection	Check sensor holder and linkage for damage	"End"	Replace sensor holder and linkage "End"