Left / right traffic conversion for Xenon headlights: Notes
WARNING:
Warning signs (yellow triangle with black high-voltage arrow) indicate high voltage (risk of fatal injury)!
The light should always be switched off when the components (control module, gas discharge lamp, drive motor) are removed and installed. A removed headlight does not have a high voltage.
The gas discharge lamp (D2S lamp) should only be operated when installed in the reflector and in the installed headlight.
NOTE:
- The masking film for left/right-hand traffic should not be removed from Xenon headlights!
- In the headlight there is a changeover lever for driving in countries with left- or right-hand traffic!
- The changeover lever is located on the left and right of the housing beside the gas discharge lamp!