Alignment Card - Gt2
ALIGNMENT CARD - GT2
| Porsche measurement of running gear | ||||
| Customer: | Rep. Order No.: | |||
| Street: | Vehicle Ident No.: | |||
| Place: | Licence number: | |||
| Telephone: | Date of first registration: | |||
| Odometer reading: : km/miles | ||||
| Measurement made by: | Date / signature: | |||
| Vehicle: 911 GT2 (996) M002 and M003 | Model: | |||
| Measurement precondition (vehicle weight): | empty weight as in DIN 70020. | |||
| This includes: full fuel tank and vehicle with tools. | ||||
| Reason for measurement: | ||||
| Make of tires: | Size/model at front: | Rear: | ||
| front left | front right | rear left | rear right | |
| Tire pressure of cold tires (bar) | ||||
| Tire/wheel (any damage) Tires - tread depth (mm) | ||||
| Incoming measurement | Nominal values/ (max. difference I./r. <__>) | Outgoing measurement | ||
| Vehicle height: | ||||
| Front (mm) | left/right | |||
| Rear (mm) | left/right | |||
| Porsche measurement of running gear | ||||
| Rear axle: | ||||
| Camber | left/right | - 1° 50' +/- 5' / (max.10' <__>) | ||
| Toe | left/right | + 13' +/- 2' / (max. 5' <__>) | ||
| total | + 26' +/- 4' | |||
| Drive-axle angle | 0° 00' +/- 5' | |||
| Front axle: | ||||
| Caster | left/right | 8° +/- 30' / (max.40' <__>) | ||
| Toe-difference angle | left | - 1° 50' +/- 30' | ||
| right | - 1° 50' +/- 30' | |||
| Camber | left/right | - 1° +/- 5' / (max. 10' <__>) | ||
| Toe | left/right | + 4' +/- 1' | ||
| total | + 8' +/- 2' | |||
Since mainly electronic wheel-alignment testers in conjunction with printers are used, a specimen alignment card is rarely required nowadays. In order for measured results to be documented in individual cases, however, a copy of the alignment card shown above can be used. See ALIGNMENT CARD - GT2 .
NOTE:
- In practice this means that alignment cards cannot be ordered!
- The alignment cards can be used for all 911 GT2 (996), M002 = street vehicle and M003 = club sport version!
- Prepare copies of the corresponding alignment card.
- Before measurement, enter the general data, vehicle model and the missing nominal values into the copied alignment card.NOTE: Actual values that are identical in all versions have already been entered!
- Enter the appropriate version, for example, M002 OR M003, in the model column.
- Carry out incoming measurement (actual state) and enter the values in the alignment card!
- After adjustments (if these were necessary), enter the actual values in the column outgoing measurement.