LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 GT2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 40 (Rear Wheel Suspension, Axle Shaft - 911 CARRERA (996)) >> Removing and installing rear spring strut >> Installation

Removing and installing rear spring strut: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install in reverse order. Before installing, give the parts a visual check. Replace fastening nuts.
  2. Do not grease screwed connections in Dacromet finish - aluminium color. Use correct tightening torques.
  3. Insert spring strut into vehicle. Before tightening the fastening nuts, adjust spring strut mount in accordance with the applied marking (position of the three fastening nuts). Tightening torque: 46 N.m (34 ftlb.)
  4. When new parts are installed that affect vehicle height, suspension alignment must be carried out.
scientia non olet · About LEMON Manuals