LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 GT2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Exterior Lights, Lamps, Switches - 911 CARRERA (996)) >> Removing and installing front angle sensor for automatic headlight beam adjustment >> Removal

Removing and installing front angle sensor for automatic headlight beam adjustment: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove front underside panel.
  2. Hold the rotary lever of the linkage with the second open-ended wrench and detach. Push back the rubber cover over the electrical plug connection and detach the plug connection from the angle sensor.
    Fig 1: Detaching Plug Connection From Front Angle Sensor
    G03063664Courtesy of PORSCHE OF NORTH AMERICA, INC.
  3. Detach the retaining bracket for the angle sensor from the side member from below.
    Fig 2: Detaching Retaining Bracket For Front Angle Sensor From Side Member
    G03063665Courtesy of PORSCHE OF NORTH AMERICA, INC.
  4. Detach the angle sensor from the retaining bracket and remove it.
scientia non olet · About LEMON Manuals