LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 GT2 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Exterior Lights, Lamps, Switches - 911 CARRERA (996)) >> Removing and installing drive motor for headlight beam adjustment >> Removal

Removing and installing drive motor for headlight beam adjustment: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the headlight and open the rear cover. Disconnect the electrical plug connection on the drive motor.
  2. Undo the fastening screw and remove the drive motor by turning counter-clockwise (bayonet lock).
    Fig 1: Undoing Fastening Screw & Removing Drive Motor For Headlight Beam Adjustment
    G03063603Courtesy of PORSCHE OF NORTH AMERICA, INC.
  3. Swivel the drive motor up, press down the locking tab (arrow) with a small screwdriver and carefully pull out the drive motor (plastic housing).
    Fig 2: Removing Drive Motor For Headlight Beam Adjustment Plastic Housing
    G03063604Courtesy of PORSCHE OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals