Left / right traffic conversion for Litronic headlights: Notes
WARNING: This page is about a different variant/trim than selected.
WARNING:
Warning signs (yellow triangle with black high-voltage arrow) indicate high voltage (risk of fatal injury).
- The light must always be switched off when removing and installing these components (control module, ignition unit, gas discharge lamp, servo motor). Once removed, a headlight is not under high voltage.
- The gas discharge lamp (D2S lamp) may only be operated when installed in the reflector and with the headlight installed.
NOTE:
Masking film for left/right-hand traffic must not be affixed to Litronic headlights. These headlights incorporate a changeover lever for driving in countries with left/right-hand traffic. This lever is located on the left and right on the housing in front of the gas discharge lamp.