Adjustment procedure

WARNING: This page is about a different variant/trim than selected.

Adjust fastening nuts to the same height as the old version and tighten slightly by hand.
Fig 1 shows mounting plate removed.

Fig 1: Adjusting Headlight Fastening Nuts
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Press headlight housing firmly into the body and lock.
The correct adjustment is described in items A...C.
After adjustment, tighten the fastening nuts to 8 +/- 2 Nm (6 +/- 1.5 ftlb.). The headlight washer nozzle can be adjusted at the holder.

NOTE: The plug housing in the mounting plate is unlocked with a commercially available screwdriver. Apply screwdriver and press down (see Fig 2 ).

Fig 2: Unlocking Mounting Plate Plug Housing

Courtesy of PORSCHE OF NORTH AMERICA, INC.

Before installing the headlight housing, ensure that the headlamp vent is plugged onto the plug housing.