Adjustment instructions

WARNING: This page is about a different variant/trim than selected.

Item A

The transition from the headlight housing to the body is in the same plane (level).

Items B and C

The headlamp housing should lie approximately 2 mm below the body edge.

Fig 1: Identifying Thickness Of Headlamp Housing

Courtesy of PORSCHE OF NORTH AMERICA, INC.

NOTE: The fastening nuts of the adjusting components are fitted at the factory as shown in Fig 2 .

Fig 2: Identifying Factory Fitted Fastening Nut Location

Courtesy of PORSCHE OF NORTH AMERICA, INC.

In the event of an accident repair or replacement of the headlights, the fastening nuts should be fitted as in Fig 3 . This ensures greater possibilities for adjusting the mounting plate.

Fig 3: Identifying Fitting Of Fastening Nut

Courtesy of PORSCHE OF NORTH AMERICA, INC.