Installing bulbs

WARNING: This page is about a different variant/trim than selected.

CAUTION: Danger of damage to property if bulbs are used or handled incorrectly!

Danger of injury. When installed, the headlight is under high voltage.

Only bulbs specified in the bulb table may be used!
Bulbs with a higher wattage may cause damage to the bulb housing!
To prevent short circuits, the load in question must be switched off while bulbs are changed!
New bulbs must be clean and free of grease. Therefore, never touch bulbs with your bare hands! To change the bulbs, use a cloth or soft paper.
Observe the safety instructions when replacing a bulb in a Litronic or Xenon headlight.
In certain states, it is compulsory to carry spare light bulbs.