Control module replacement
CAUTION:
Moisture can cause corrosion! Fluids must not come into contact with the connector!
If the control module is damaged, the complete hydraulic unit with integrated control module must be replaced. Observe the following points:
- The control module must be coded for the corresponding type of transmission (manual transmission/Tiptronic).
- The Vehicle Identification Number must be entered.
- A static test and the swap test must be carried out with the PST2.
NOTE:
Observe the allocation to the rate-of-turn sensor! The control module with part No. 996.618.149.02 performs a self-test of the rate-of-turn sensor. This control module must be installed only in combination with the rate-of-turn sensor with part No. 996.606.145.00. The allocation is listed in the CONTROL MODULE & RATE-OF-TURN SENSOR APPLICATION GUIDE
.
CONTROL MODULE & RATE-OF-TURN SENSOR APPLICATION GUIDE
| PSM control module/hydraulic unit | Rate-of-turn sensor |
|---|---|
| 996.618.149.01/ 996.355.955.51 | 996.606.147.00 or 996.606.145.00 |
| 996.618.149.02/ 996.355.955.57 | 996.606.145.00 |