LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 GT2 >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical - 911 Turbo (996) >> Removing and installing the front brake disc >> Removal

Removing and installing the front brake disc: Removal

NOTE: In order to gain better access for assembly work, it is beneficial to turn the wheels fully either to the right or the left!
  1. Remove front wheel. Press the electrical lead for the speed sensor/wear indicator out of the holder.
  2. Undo the plug coupling for the speed sensor/wear indicator on the wheel carrier.
  3. Loosen holder for brake line at wheel carrier.
  4. Disengage the electrical lead for the wear indicator from the clips.
  5. Set the brake pads back slightly with the piston resetting fixture.
  6. Undo the brake caliper on the wheel carrier and hang it in a suitable place in the wheel well (do not open the brake hydraulics!).
  7. Take off the brake disc after removing the countersunk screws.
scientia non olet · About LEMON Manuals