General information
- Never hang the Porsche System Tester II 9588 over the steering wheel
- Tools and special tools should in general be kept away from all airbag operating areas and the roll-over protection strap area.
The Porsche System Tester II 9588 is a modular, portable diagnostic and measuring system. It can be used in any location to perform diagnostic tests on electronic control units. It consists of a computer unit, a main memory, a hard disk, a VGA display panel, a rechargeable nickel metal hydride battery and a measuring unit for measurement of current, voltage and resistance values.
The Porsche System Tester 2 can be operated with the built-in keys or using a connectable country-specific PS/2 keyboard (option).
Data and measured values can be printed out on DIN A4 printers currently approved by Porsche.
The integrated LCD panel is used as the display. A monitor can also be connected (VGA connection).
If a printer or PS/2 keyboard is connected, the corresponding device type must be set under Configuration in the start-up screen.
The following tasks can be performed:
- Reading out the control-unit identification
- Read out fault memory
- Erase fault memory
- Testing the drive links
- Testing the input signals
- Reading out actual values
- Control unit programming
- Special functions (vehicle hand-over, cooling system)
- Current, voltage and resistance measurements