Installing cover for the seat cushion.
PROCEDURE FOR INSTALLING COVER FOR SEAT CUSHION
| No. | Procedure | Instructions |
|---|---|---|
| 1 | Mounting the seat cover on to the foam part (seat cushion) | Position seat cover covering strips -C-A-D-E-B-A- |
| 2 | Mounting the seat cover on to the cushion carrier | Note: -4-4-E- The plastic clips -4-4-E- |
| 3 | Fitting seat cover onto the cushion carrier Installing cushion carrier |
Fit the seat cover over the foam part so that it is free from wrinkles. Push the push-on bead -3-1-2- See INSTALLING FRONT CUSHION CARRIER |
| Remedying creases in the backrest cover | If creases form in the areas of the backrest cover, heat them partially with the hot-air gun. |
CAUTION:
- Danger of material damage if excessive heat is applied!
- If creases form, only short partial warming with the hot-air gun is permissible. Always observe the hot-air temperature of approx. 50 degrees Celsius (122 Fahrenheit).