Bleeding The Pump Unit
BLEEDING PUMP UNIT
| No. | Procedure | Instructions |
| 1 | Pulling out pump | Pull hydraulic cylinder -2- out to the dimension -Y = 35 +2 mm- . To do this, connect 12 V to the pump. Observe polarisation arrangement -A- . |
| 2 | Bleeding short hydraulic line | Slowly tighten short hydraulic line -4- until the hydraulic cylinder -2- moves. If the hydraulic cylinder has reached the lower mechanical stop -inset X- , push back onto the stop if necessary, hydraulic lines must be laid parallel to each other -inset Z- . Tighten banjo bolt -3- . Tightening torque: 15 Nm (11 ftlb.) |
| 3 | Bleeding long hydraulic line | Slowly tighten long hydraulic line -5- until the hydraulic cylinder -2- moves. If the hydraulic cylinder has reached the lower mechanical stop -inset X- , push back onto the stop if necessary, hydraulic lines -inset Z- must be laid parallel to each other. Tighten banjo bolt -3- . Tightening torque: 15 Nm (11 ftlb.) |
| Installing pump unit | Refer to DISASSEMBLING AND ASSEMBLING REAR LID |