Exterior Lights, Lamps, Switches Diagnosis - 911 Turbo (996)

• Introduction
  • Notes
  • General instructions / safety instructions
  • General information on the fault memory
    • Fault code setting conditions
    • Fault memory Info key "F8"
      • Notes
      • Open circuit - short to ground / voltage short / version; vehicle parameters / counter
• Tools
  • Notes
  • Porsche System Tester 2 (PST 2)
  • Commercially available digital multimeter
• Component arrangement
• Connector assignment
  • Connector assignment for HBA control module
• Control module function
  • Coding
    • Notes
    • Procedure
  • Calibration
    • Notes
    • Procedure
• Fault overview
• Fault code 1
  • Engine path, left
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/Troubleshooting
• Fault code 2
  • Engine path, right
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/Troubleshooting
• Fault code 3
  • Axle position sensor, front (angle sensor for HBA)
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/Troubleshooting
• Fault code 4
  • Axle position sensor, rear (angle sensor for HBA)
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/Troubleshooting
• Fault code 5
  • 5 V supply for axle position sensors (angle sensors for HBA)
    • Diagnostic conditions
    • Possible cause of fault
    • Affected terminals
  • Diagnosis/Troubleshooting
• Fault code 6
  • Control unit coding error
    • Diagnostic conditions
    • Possible cause of fault
  • Diagnosis/Troubleshooting
• Fault code 7
  • Calibration not performed yet
    • Diagnostic conditions
    • Possible cause of fault
  • Diagnosis/Troubleshooting