Input signals

The following queries can be run using this menu item:

NOTE: Deactivate the automatic traffic announcement before performing the diagnosis on the PCM2. If this is not done, the diagnosis will abort.

INPUT SIGNALS ITEM FUNCTION CHART - AUTOMATIC TRAFFIC ANNOUNCEMENT

Menu item	Function
Tuner parameters	Under this menu item, it is possible to check the electrical and optical MOST during troubleshooting. Connect and start the Porsche System Tester II 9588 and switch on the ignition Select 911 Turbo (996) in the Vehicle type menu and confirm with the "->\|" key Select PCM in the Control units menu and confirm with the ">>" key Select PCM2-GW in the PCM2 function selection menu and confirm with the ">>" key Select the Input signals menu item and confirm with the ">>" key Select the Tuner parameters menu item using the ">" key and press the ">>" key Read out values from the display field Registry startup status required installed components list exists Internal ring startup status internal MOST (electrical) is functional External ring startup status external MOST (optical) is functional

Menu item

Function

Under this menu item, it is possible to check the electrical and optical MOST during troubleshooting.

Connect and start the Porsche System Tester II 9588 and switch on the ignition
Select 911 Turbo (996) in the Vehicle type menu and confirm with the "->|" key
Select PCM in the Control units menu and confirm with the ">>" key
Select PCM2-GW in the PCM2 function selection menu and confirm with the ">>" key
Select the Input signals menu item and confirm with the ">>" key
Select the Tuner parameters menu item using the ">" key and press the ">>" key
Read out values from the display field
Registry startup status required installed components list exists
Internal ring startup status internal MOST (electrical) is functional
External ring startup status external MOST (optical) is functional