Drive links

Drive links of the PCM2 can be activated with this menu item. This allows the function of the drive links to be assessed very quickly.

The following drive links can be activated with the Porsche System Tester II 9588:

Display colour black
Display colour coloured bars
Display colour blue
Display colour red
Display colour green
Display colour white
NOTE: The activated drive link is automatically switched off after approximately 20 seconds.

DRIVE LINK ITEM FUNCTION CHART

Menu item	Function
Display colour black	Using this menu item, the function Display colour black can be checked. Connect and start the Porsche System Tester II 9588 and switch on the ignition. Select 911 Turbo (996) in the Vehicle type menu and confirm with the ">>" key. Select PCM2 in the control modules selection and confirm with the ">>" key. Select PCM2 MMI in the 911 Turbo (996) function selection and confirm with the ">>" key. Select Drive links in the PCM2 MMI menu and press the ">>" key. Select Display colour black in the PCM2-MMI Drive links menu with the ">" key and confirm with the ">>" key. The display must show the correct colour. Proceed in the same way with the following tests. Display colour coloured bars Display colour blue Display colour red Display colour green Display colour white

Menu item

Function

Using this menu item, the function Display colour black can be checked.

Connect and start the Porsche System Tester II 9588 and switch on the ignition.
Select 911 Turbo (996) in the Vehicle type menu and confirm with the ">>" key.
Select PCM2 in the control modules selection and confirm with the ">>" key.
Select PCM2 MMI in the 911 Turbo (996) function selection and confirm with the ">>" key.
Select Drive links in the PCM2 MMI menu and press the ">>" key.
Select Display colour black in the PCM2-MMI Drive links menu with the ">" key and confirm with the ">>" key.
The display must show the correct colour.

Proceed in the same way with the following tests.