Input signals
The following queries can be run using this menu item:
NOTE:
Deactivate the automatic traffic announcement before performing the diagnosis on the PCM2. If this is not done, the diagnosis will abort.
INPUT SIGNALS ITEM FUNCTION - AUTOMATIC TRAFFIC ANNOUNCEMENT
| Menu item |
Function |
|
|
Under this menu item, it is possible to check the electrical and optical MOST during troubleshooting.
- Connect and start the Porsche System Tester II 9588 and switch on the ignition
- Select 911 Turbo (996) in the vehicle type menu and confirm with the "->|" key.
- Select PCM in the control units selection and confirm with the ">>" key.
- Select PCM2/CDR23 in the control units selection and confirm with the ">>" key.
- Select PCM2 GW in the PCM2 function selection and confirm with the ">>" key
- Select the Input signals menu item and press the ">>" key
- Select the 3dB loss
menu item using the ">" key and press the ">>" : key
- Read out values from the display field.
|