Control unit function - CD changer: Coding
It is possible to extract the chassis number and to code the PCM2 on a country-specific basis in the Modify coding menu.
CD CHANGER (CDC) CODING
| Menu item |
Function |
|
|
It is possible to extract or enter the chassis number under this menu item after replacing the PCM2.
- Connect and start the Porsche System Tester II 9588 and switch on the ignition
- Select 911 Turbo (996) in the vehicle type menu and confirm with the "->|" key.
- Select PCM in the control units selection and confirm with the ">>" key.
- Select PCM2/CDR23 in the control units selection and confirm with the ">>" key.
- Select PCM2 GW in the PCM2 function selection and confirm with the ">>" key
- Select menu item Coding
- Select the Chassis number
menu item
- Enter the chassis number and code with the "F8" key
|
|
|
Using this menu item, you can code the country code.
- Connect and start the Porsche System Tester II 9588 and switch on the ignition
- Select 911 Turbo (996) in the vehicle type menu and confirm with the "->|" key.
- Select PCM in the control units selection and confirm with the ">>" key.
- Select PCM2/CDR23 in the control units selection and confirm with the ">>" key.
- Select PCM2 GW in the PCM2 function selection and confirm with the ">>" key
- Select the coding menu item and confirm with the ">>" key.
- Select the menu item Country coding
and confirm with the ">>" key.
- Select the relevant country coding
from the menu item that is displayed and code it with the "F8" key
|