Input signals

The following queries can be run using this menu item:

Tuner parameters.
Registry startup status.
Internal ring startup status.
External ring startup status.

NOTE: Deactivate the automatic traffic announcement before performing the diagnosis on the PCM2. If this is not done, the diagnosis will abort (only applicable to version number < 03).

INPUT SIGNALS ITEM FUNCTION CHART - AUTOMATIC TRAFFIC ANNOUNCEMENT

Menu item	Function
Tuner parameters	Using this menu item, you can code the tuner parameters. Connect and start the Porsche System Tester II 9588 and switch on the ignition. Select vehicle type 911 (996) and the PCM2-GW control module and press the ">>" key. Select the Input signals menu item and press the ">>" key. Select the Tuner parameters menu item using the ">" key and press the ">>" key. Read out values from the display field.
Registry startup status	It is displayed under this menu item that installed MOST control modules can be read out from the actual installed components list. Connect and start the Porsche System Tester II 9588 and switch on the ignition. Select vehicle type 911 (996) and the PCM2-GW control module and press the ">>" key. Select Input signals and press the ">>" key Select the Registry startup status menu item using the ">" key and press the ">>" key. Read out values from the display field.
Internal ring startup status	It is displayed under this menu item that installed MOST control modules in the internal ring can be read out from the actual installed components list. Connect and start the Porsche System Tester II 9588 and switch on the ignition. Select vehicle type 911 (996) and the PCM2-GW control module and press the ">>" key. Select the Input signals menu item and press the ">>" key. Mark the Internal ring startup status menu item using the ">" key and press the ">>" key. Read out values from the display field.
External ring startup status	It is displayed under this menu item that installed MOST control modules on the external ring can be read out from the actual installed components list. Connect and start the Porsche System Tester II 9588 and switch on the ignition. Select vehicle type 911 (996) and the PCM2-GW control module and press the ">>" key. Select the Input signals menu item and press the ">>" key. Mark the External ring startup status menu item using the ">" key and press the ">>" key Read out values from the display field.