General instructions/safety instructions
The following points must be observed during vehicle diagnosis:
- After the battery is connected, volatile memories must be reprogrammed. In the case of radio coding and tuning, the customer must be informed of decoding and the deleted tuner memory.
- After the battery has been connected, the instructions in the assembly must be observed. Refer to WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY .
- Deactivate the automatic traffic announcement before beginning the diagnosis on CDR23. If this is not done, the system will crash (applies only to software version < 03).
- When working on the optical waveguide, please observe the instructions in assembly. Refer to OPTICAL WAVEGUIDE - MOST BUS .
- After troubleshooting or repairs, erase the fault memory with the Porsche System Tester II 9588 and carry out a test drive.
- After the test drive, read out the fault memory with the Porsche System Tester II 9588 again.
WARNING:
Danger of injury through triggering of driver's airbag
- Never hang the Porsche System Tester II 9588 over the steering wheel.
CAUTION:
Danger of damage due to improper handling of the battery and the control module connectors!
- Never disconnect battery with engine running.
- Never start engine without securely connected battery.
- Never pull off or push on plug connections for the control modules or other electronic components when the ignition is switched on.