Removing and installing hydraulic pump
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Damage to hydraulic lines. Do not bend, trap or crush hydraulic lines during installation. Pay special attention when routing hydraulic lines in the clips.
HYDRAULIC PUMP REMOVAL AND INSTALLATION PROCEDURE - AS OF MY 2002
| No. | Designation | Qty. | Removal | Installation |
|---|---|---|---|---|
| 1 | Electrical plug connection | 2 | Disconnect electrical plug connection -1-inset- . See Fig 1. | Connect electrical plug connection -1- . See Fig 1. |
| 2 | Fastening nut | 4 | Unscrew. | See TIGHTENING TORQUES . |
| 3 | Bracket with hydraulic pump | 2 | Unscrew collar nuts -2- . See Fig 1. | See REMOVING AND INSTALLING HYDRAULIC PUMP AS OF MODEL YEAR 2003 . |
| 4A | Banjo bolt | 1 | Lay cloth under banjo bolt before unscrewing -4A- . See Fig 1. | Push on sealing rings -5, 6-A-4A- . See Fig 1. |
| 4B | Banjo bolt | 1 | Lay cloth under hydraulic pump before unscrewing banjo bolt -4B- . See Fig 1. | Push on sealing rings -5, 6-B-4B- . See Fig 1. |
| 5 | Sealing ring A8 x 12, 1 thick | 4 | Always replace sealing ring -5- . See Fig 1. | |
| 6 | Sealing ring A8 x 12, 2 thick | 2 | Always replace sealing ring -6- . See Fig 1. | |
| 7 | Plug G 1/8 inch | 1 | See TIGHTENING TORQUES . | |
| 8 | Sealing ring A10 x 14, 1 thick | 1 | Always replace sealing ring -8- . See Fig 1. |