Tools and materials
WARNING: This page is about a different variant/trim than selected.
The following tools and materials are required to construct the fixture for work in the inner area.
HARDTOP ASSEMBLY FIXTURE TOOLS AND MATERIALS (INNER AREA)
| Item | Designation | Explanation |
|---|---|---|
| Drill | ||
| Drill bit 6 mm | ||
| Drill bit 3 mm | ||
| Sabre saw | ||
| Tape measure | ||
| -B- . See Figure. | Support cheek (2x) | Multiplex plate 25 mm thick, 600 x 120 mm |
| -C- . See Figure. | Swivel arm (1x) | Multiplex plate 25 mm thick, 550 x 200 mm |
| -D- . See Figure. | Base plate (1x) | Wood-core plywood 19 mm thick, 1500 x 900 mm |
| -E- . See Figure. | Boom (1x) | Hardwood block 30 mm thick, 650 x 50 mm |
| -F- . See Figure. | Support (1x) | Hardwood block 50 mm thick, 90 x 140 x 190 mm |
| All materials listed are commercially available. | ||
| Set of fittings includes: | ||
| -A1- . See Figure. | Bracket (1x) | |
| -A2- . See Figure. | Hinge (1x) | |
| -A3- . See Figure. | Contact surface (2x) | |
| -A4- . See Figure. | Cylindrical pin 6 M6 x 40 (6x) | |
| -A5- . See Figure. | Countersunk screw 4.5 x 20 (8x) | |
| -A6- . See Figure. | Countersunk screw 6 x 20 (2x) | |
| -A7- . See Figure. | Countersunk screw 6 x 20 with disc (4x) | |
| -A8- . See Figure. | Countersunk screw 6 x 60 (2x) | |
| -A9- . See Figure. | Countersunk screw 6 x 50 (3x) | |