LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Differential, Transaxle System) >> Adjusting The Drive Set (Transmission G 86) >> Adjustment And Labelling Of The Drive Sets (Transmission G 86) >> Drive Set In The Series

Drive Set In The Series

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: In the series, the position of the output shaft is determined by the dimension Po (centre of the crown wheel to the rear of the output shaft head). The labellings of the deviation "r" on the crown wheel and the pairing number are not present. Due to the deviation "r" not being given, before the output shaft is replaced it is necessary to carry out an actual measurement if parts are being replaced which directly influence the installation position of the output shaft. Refer to DETERMINING THE INSTALLATION POSITION OF THE OUTPUT SHAFT (ACTUAL MEASUREMENT)  .

X These details are not required in the series.

Po Adjustment dimension for the series.

scientia non olet · About LEMON Manuals