Adjustment Overview (Transmission G 86)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
When carrying out assembly work on the final drive, readjustment of the output shaft and crown wheel or drive set is necessary only if parts are being replaced which directly influence the adjustment of the final drive. In order to avoid unnecessary adjustment work, pay attention to the following table:
DRIVE SETS ADJUSTMENT (TRANSMISSION G 86)
| The following must be adjusted | crown wheel (S1 + S2) | output shaft (S3 + S4) over dimension "r" | output shaft (S3 + S4) over actual measurement | output shaft adjusting shim only S4 | ||
| Replaced part | ||||||
| Transmission housing (1) | ||||||
| Transmission case cover | X | |||||
| Differential housing | X | |||||
| Tapered roller bearing for output shaft | X | |||||
| Tapered roller bearing for differential | X | |||||
| Drive set | X | X | ||||
| Cover for final drive | X | |||||
|
||||||