LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Radio, Navigation, Telephone, Pcm & Park Assistant - Diagnosis) >> Control unit function - gateway >> Audio tests

Audio tests

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

The following functions can be run using this menu item:

AUDIO TESTS MENU ITEM - FUNCTIONS

Menu item Function
  • Manual single selection
A manual audio test can be carried out using this menu item.
  • Connect and start the Porsche System Tester II 9588 and switch on the ignition.
  • Select Boxster (986) in the Vehicle type menu and confirm with the ">>" key.
  • Select PCM in the control modules selection and confirm with the ">>" key.
  • Select PCM2 GW in the PCM2 function selection and confirm with the ">>" key.
  • Select the Audio tests menu item.
  • Select Manual single selection  menu item.
  • Select a particular system and confirm with the ">>" key.

The following selection is available:
  • Front left, test frequency 1 kHz
  • Front right, test frequency 1 kHz
  • Door speaker left, test frequency 1 kHz
  • Door speaker right, test frequency 1 kHz
  • "F5" Boost volume
  • "F6" Lower volume
  • "F8" Start test
  • Automatic test
A manual audio test can be carried out using this menu item.
  • Connect and start the Porsche System Tester II 9588 and switch on the ignition.
  • Select Boxster (986) in the Vehicle type menu and confirm with the ">>" key.
  • Select PCM in the control modules selection and confirm with the ">>" key.
  • Select PCM2 GW in the PCM2 function selection and confirm with the ">>" key.
  • Select the Audio tests menu item and confirm with the ">>" key.
  • Select the Automatic test menu item and confirm with the ">>" key.

The test sequence is automatic.