Drive links

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

Drive links of the CDR23 can be activated with this menu item. This allows the function of the drive links to be assessed very quickly using the Porsche System Tester II 9588.

The following drive links can be activated:

All On display test
Display check

DRIVE LINKS MENU ITEM - FUNCTION (CDR23 CONTROL MODULE)

Menu item	Function
All On display test	Under this menu item, the function of the CDR23 display segments can be checked. Connect and start the Porsche System Tester II 9588 and switch on the ignition Select Boxster (986) in the Vehicle type menu and confirm with the ">>" key Select PCM in the Control units selection menu and confirm with the ">>" key Select CDR23 in the Boxster (986) CDR23 function selection menu and confirm with the ">>" key Select Drive links in the Boxster (986) CDR23 function selection menu and confirm with the ">>" key Select All On display test in the Boxster (986) CDR23 drive links menu using the ">" key and confirm with the ">>" key Press the "F8" key to start the test All segments of the CDR23 display are activated and can be checked for operation

Menu item

Function

All On display test

Under this menu item, the function of the CDR23 display segments can be checked.

Connect and start the Porsche System Tester II 9588 and switch on the ignition
Select Boxster (986) in the Vehicle type menu and confirm with the ">>" key
Select PCM in the Control units selection menu and confirm with the ">>" key
Select CDR23 in the Boxster (986) CDR23 function selection menu and confirm with the ">>" key
Select Drive links in the Boxster (986) CDR23 function selection menu and confirm with the ">>" key
Select All On display test in the Boxster (986) CDR23 drive links menu using the ">" key and confirm with the ">>" key
Press the "F8" key to start the test
All segments of the CDR23 display are activated and can be checked for operation