800B PCM2 - gateway: Diagnosis/troubleshooting
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS/TROUBLESHOOTING - 800B PCM2 - GATEWAY
| Work instruction |
Display OK |
If not OK |
| 1 |
Read out PCM2 fault memory |
- Connect the Porsche System Tester II 9588 to the diagnostic socket, start it and switch on the ignition.
- Select Boxster in the Vehicle type menu and confirm with the ">>" key.
- Select PCM in the control modules selection and confirm with the ">>" key.
- Select PCM2/CDR23 in the control modules selection and confirm with the ">>" key.
- Select PCM2 GW in the PCM2 function selection and confirm with the ">>" key.
- Click the ">>" key in the Fault memory menu.
- Read out fault memory.
- Erase fault memory.
- Remove ignition key and switch on ignition again.
- Read out fault memory.
- Extract ambient data, press the ">>" key.
|
-> End |
Step 2 |
| 2 |
Read out instrument cluster fault memory |
- Connect the Porsche System Tester II 9588 to the diagnostic socket; switch on the ignition and the Porsche System Tester II 9588.
- Select 986 as the vehicle type and start the automatic control module search.
- In the Control units menu, select Instrument cluster.
- Click the ">>" key in the Fault memory menu.
- Read out fault memory.
- Erase fault memory.
- Remove ignition key and switch on ignition again.
- Read out fault memory.
|
-> End |
Step 3 |
| 3 |
Elimination of faults |
Eliminate faults in accordance with the entry in the memory |
-> End |
Step 4 |
| 4 |
Replace PCM2 |
-> End |
- |