LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine) >> Removing And Installing Solenoid Hydraulic Valve >> Removal

Removing And Installing Solenoid Hydraulic Valve: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove solenoid hydraulic valve.
    NOTE:
    • Install the solenoid valve only if the VarioCam tensioning element is vertical. Correct seating of the compression spring (No. 4) is no longer ensured if the solenoid hydraulic valve is installed horizontally (installation position of engine).
  2. Undo self-tapping screws (Torx T 20) No. 1.
    NOTE:
    • Mark a threaded screw and threaded bore for reinstallation:
  3. Remove solenoid valve. Leave valve plunger and compression spring in installation position.
scientia non olet · About LEMON Manuals