LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine) >> Removing And Installing Hydraulic Valve For Camshaft Adjustment - Engine Installed, As Of My 2003 >> Removing The Hydraulic Valve

Removing The Hydraulic Valve

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Risk of soiling! Absolute cleanliness is essential when working with hydraulic valves!
  1. Remove respective rear wheel. To do this, use the socket wrench insert P 300 to avoid damaging the wheel.
  2. Remove cable plug of the hydraulic valve -1-  by pressing the clip and pulling off the cable plug. See Fig 1.
    Fig 1: Removing Cable Plug Of Hydraulic Valve
    G03092568Courtesy of PORSCHE OF NORTH AMERICA, INC.
  3. Unscrew the two M6 pan-head screws (hexagon socket a/f 5) of the valve holder Fig 1 and remove the holder with the screws -A-  . See Fig 2.
    Fig 2: Removing Holder With Screws
    G03092569Courtesy of PORSCHE OF NORTH AMERICA, INC.
  4. Remove retainer plate with integral seal from the valve. See Fig 1.
  5. Carefully pull the hydraulic valve out of the cylinder head using special tool (relay puller) 9235. Mask the valve sheath with fabric tape to avoid damage.
    Fig 3: Pulling Hydraulic Valve Out Of Cylinder Head
    G03092570Courtesy of PORSCHE OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals