LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine) >> Removing And Installing Drive Belt >> Removing Drive Belt

Removing Drive Belt

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
REMOVAL PROCEDURE FOR DRIVE BELT

No. Procedure Instructions
1 Remove left-hand seat Disconnect the electrical plug connection. Undo four Torx screws with socket TX 50 (3/8 inch).
2 Remove rear wall cover on passenger compartment rear wall Remove rear wall lining. Unscrew seven hexagon-head bolts and two hexagon nuts (a/f 10 mm) and remove cover.
3 Remove drive belt Mark belt travel direction with a colored pen. Slacken belt by turning the tensioning pulley (a/f 24 mm) clockwise, hold still and simultaneously take the belt off the drive pulleys. Visually inspect the condition of the belt and replace it if necessary.
scientia non olet · About LEMON Manuals