LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Engine) >> Removing And Installing Closure Cap For Camshaft Bore - Engine Installed >> Installing Closure Caps At Pulley Side Of Cylinder Head 4 - 6

Installing Closure Caps At Pulley Side Of Cylinder Head 4 - 6

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean receiving bore. Fit new cap dry and press in as far as it will go.
  2. Install rear wall lining and rear wall cover.

Tightening torque 10 Nm (7.5 ft.lb) 

scientia non olet · About LEMON Manuals