Tightening Torques
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
TIGHTENING TORQUES - INSTALLING ENGINE, M96/20 (2.5L) WITH TIPTRONIC TRANSMISSION
| Location | Thread | Tightening Torque Nm (ft.lb) |
|---|---|---|
| Torque converter to drive plate | M8 | 39 (29) |
| Engine carrier to body | M10 x 1.5 | 65 (48) |
| Transmission support on transmission | M10 x 1.5 | 65 (48) |
| Hydraulic mount to carrier side section | M8 | 33 (24) |
| Drive shaft on transmission | M8 | 39 (29) |
| Aluminum V-brace | M10 x 1.5 | 65 (48) |
| Cable to rear-axle support | M8 | 23 (17) |
| Exhaust system to exhaust manifold | M8 | 25 (19) |
| Stabilizer to carrier side section | M8 | 23 (17) |
| Stabilizer to coupling linkage | M10 x 1.5 | 50 (37) |
| Sheetmetal brace to carrier side section (hexagon nut) | M10 x 1.5 | 65 (48) |
| Sheetmetal brace to cross member (hexagon-head bolt) | M10 x 1.5 | 46 (34) |
| Sheetmetal brace to V-brace (hexagon nut) | M10 x 1.5 | 65 (48) |
| Diagonal brace (front) to body | M10 x 1.5 | 65 (48) |
| Diagonal brace to carrier side section (hexagon nut) | M10 x 1.5 | 65 (48) |
| Wheel to wheel hub | M14 x 1.5 | 130 (96) |
| Fuel supply line on fuel gallery | M16 | 30 (22) |
| Coolant drain plug | M10 x 1 | 10 (7.5) |
| Ground strap to secondary air pump bracket | M8 | 23 (17) |