LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Wiring) >> Removing And Installing Fusible Element In The Current Distributor >> Allocation Of Free Fuse Connection Points

Allocation Of Free Fuse Connection Points

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Additional loads must not be connected to the existing free fuse locations in the fuse box!

The load on the fusible elements in the current distributor was carefully set during development. Connecting additional loads could lead to an overload in the current distributor or to disturbances in the vehicle electrical system.

If an external load should nevertheless be installed subsequently, this must be connected directly to B+ with corresponding fuse protection (line fuse). Cables can be routed into the passenger compartment through the service opening in the firewall (closed off by a rubber sleeve behind the battery) and the appropriate seal.

scientia non olet · About LEMON Manuals