LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Exterior Lights, Lamps, Switches) >> Removing And Installing Drive Motor For Headlight Beam Adjustment >> Removal

Removing And Installing Drive Motor For Headlight Beam Adjustment: Removal

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch off light. Disengage headlight housing and pull forwards a little.
  2. Disconnect the electrical plug connection of the automatic headlight beam adjustment (ALWR) and remove headlight housing.
  3. Release cover with control module and open. Disconnect the electrical plug connection from the drive motor and undo the fastening screws (2 screws).
    Fig 1: Disconnecting Electrical Plug Connection From Drive Motor For Headlight Beam Adjustment
    G03092838Courtesy of PORSCHE OF NORTH AMERICA, INC.
  4. Remove ignition unit (2 fastening screws).
  5. Press down unlocking lever with a screwdriver and pull drive motor out towards the rear.
    Fig 2: Pressing Down Unlocking Lever & Removing Headlight Beam Adjustment Motor
    G03092839Courtesy of PORSCHE OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals