LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Air Conditioner) >> Removing and installing the fluid tank >> Installation

Removing and installing the fluid tank: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do not remove the plug until shortly before installation. Replace the O-ring on the branch piece and on the refrigerant line, and wet the new O-rings with refrigerant oil.
  2. Tighten both hexagon-head bolts on fluid tank with 6 Nm.
  3. Determine the quantity of the refrigerant oil and fill up again with refrigerant oil (volume removed by suction + 30 cm3 ).
NOTE:
  • The fluid tank must be replaced if the system suffers from operational faults (e.g. accident damage or air-conditioning system depressurized).
  • Refrigerant oil removed from a previously run air-conditioning system may no longer be used (special-category waste).
scientia non olet · About LEMON Manuals