LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Air Conditioner) >> Removing and installing the condenser >> Installation

Removing and installing the condenser: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Do not remove the plugs for the lines and condenser connection until shortly before installation.
  2. Replace O-rings and wet the new O-rings with refrigerant oil.
  3. Tightening torques:
    TIGHTENING TORQUES

    Refrigerant lines M6 10 Nm
    Condenser 4,0 +/- 0,5 Nm

    When loosening or tightening the M8 refrigerant lines on the condenser, always counter with a 21-mm open-ended wrench.

  4. Determine the quantity of the refrigerant oil and top up again with refrigerant oil (volume removed by suction + 20 cm3 ).
    NOTE:
    • Refrigerant oil removed by suction from a previously run air-conditioning system may no longer be used (special-category waste).
scientia non olet · About LEMON Manuals