LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Seats) >> Removing and installing motor for the lumbar support >> Installing electrical line for the lumbar

Installing electrical line for the lumbar

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
INSTALLING PROCEDURE FOR ELECTRICAL LINE FOR LUMBAR

No. Procedure Instructions
5a Electrical plug connection -5-  . See Figure . Fasten line to motor with tie wrap for the rear seat adjustment and insert plug -5-4-arrow-  . See Figure .
5b Electrical plug connection -6-  . See Figure . Join plug connection -6-  . See Figure .
6 Electrical line -7-  . See Figure . Lay line behind motor for along the lumbar support. Observe routing under the lumbar support (airbag) and along the seat frame -arrow-  . See Figure .
7 Electrical line Route the electrical line on the backrest frame parallel to the air hose -A-  . See Figure .
scientia non olet · About LEMON Manuals