Fitting Sliding Strip On The Inner Door Panel

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

A sliding strip must be stuck onto the front and rear sides of the inner door panel in order to prevent creaking noises from the door area.

Sticking sliding strip onto the front of the inner door panel
Remove backing film from the sliding strip and stick the strip onto the front of the inner door panel -arrow- . See Fig 1 . Start at the top (top edge of inner door panel) and follow the curvature.

Fig 1: Removing Backing Film From Sliding Strip And Sticking Strip Onto Front Of Inner Door Panel
Courtesy of PORSCHE OF NORTH AMERICA, INC.

Sticking sliding strip onto the rear of the inner door panel
Remove backing film from the sliding strip and stick the strip onto the rear of the inner door panel -arrow- . See Fig 2 . Start at the top (top edge of inner door panel) and follow the curvature.

Fig 2: Removing Backing Film From Sliding Strip And Sticking Strip Onto Rear Of Inner Door Panel
Courtesy of PORSCHE OF NORTH AMERICA, INC.