Safety regulations for vehicles with airbag and belt tensioner: Notes

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: As from model year 2002, the front three-point belt will be fitted with a belt tensioner as standard.

WARNING: Danger of injury and damage to property as a result of incorrect handling of airbag units! (Part 1)
Please observe the following points:

The airbag units are pyrotechnical items in hazard class T 1!
Handling, transport and storage of these units must conform to the explosives legislation!
The listed statutory requirements refer to the Federal Republic of Germany!
The relevant valid regulations must be observed in all other countries!
The commencement of work with pyrotechnical items must be reported 14 days in advance to the Trade Supervisory Office (responsible authority)!
Airbag units may only be dispatched in transport packaging officially approved for that purpose!
Airbag units may not be transported with other hazardous goods!
Internally, they must always be transported in the luggage compartment or cargo hold of a vehicle using the above-mentioned transport packaging!
They must not be transported in the passenger's compartment!
Airbag units must be stored in accordance with the second ordinance of the explosives legislation!
This ordinance stipulates that small quantities of materials and objects may be stored at certain locations without special storage approval!
According to the Explosives Storage Directive of August 1997, these quantities are max. 10 kg (net) in a work room and max. 100 kg (net) in a storage room in the case of Class T1 pyrotechnical items!

WARNING: Danger of injury and damage to property as a result of incorrect handling of airbag units! (Part 2)
Please observe the following points:

Airbag units must be kept in a locked place!
When storing airbag units, ensure that the airbag opening faces upwards (risk of injury caused by inflation of the airbag units in the event of accidental ignition)!
Airbag units must be stored in a dry place and must not be stored together with other hazardous goods (varnishes, etc.)!
Loose airbag units, referred to as airbag modules below, or airbag modules installed in a loose steering wheel must never become the actual (physical) property of the customer!
The possession of loose airbag modules not installed in the vehicle is not permissible in the private sector!
Airbag modules may become the property of the customer only when installed in the vehicle!