Conversion measure on the tension bow for the roof liner in vehicles produced before 12.04.2000
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- In vehicles with a roof liner produced before 12.04.2000, a modified roof liner with a new cut must be installed when the convertible-top covering with a small rear window is replaced
- In vehicles with production date up to 12.04.2000, the holes for the roof liner connection must be re-measured and re-drilled!
- The roof liner connection on the tension bow has been modified from a 1-point clip (threaded part) to a 2-point clip
- Measuring and drilling the holes for the roof liner
Measure the dimensions -A = 10 mm- centrally starting from the inner edge of the tension bow. See Fig 1 .
Measure the dimension -B = 128 mm- starting from the beginning of the tension bow. See Fig 1 .
Measure the dimension -C = 193 mm- starting from the centre of the hole for dimension -B- . See Fig 1 .
Centre the measured dimensions using a prick punch. Drill the centrings with a drill bit 5 mm.