LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Steering) >> Test And Assembly Work On Power-Assisted Steering >> Bleeding The Steering System

Bleeding The Steering System

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. To fill the whole system after the installation of new steering components or lines or after a substantial loss of hydraulic fluid, briefly start the engine a few times and, when it fires, switch it off again immediately. This procedure causes the fluid level in the reservoir to fall rapidly, so constantly add Pentosin CHF 11 S. The reservoir must not be sucked dry.
  2. If the fluid level in the reservoir does not fall any further when the engine is briefly turned over, start the engine and let it to run at idling speed.
  3. Rapidly turn the steering wheel from stop to stop several times so that the air can escape from the cylinders. At the end positions of the piston, do not pull the steering wheel with more force than is necessary in order to turn the steering (to prevent unnecessary build-up of pressure).
  4. Observe fluid level during this procedure. If it continues to fall, add fluid until the level in the reservoir remains constant and no more air bubbles rise in the reservoir when the steering wheel is turned.
    NOTE:
    • If the fluid levels with the engine stationary and running differ by more than 10 mm, in the hydraulic fluid still contains too much air.
  5. Correct the fluid level with the engine at idling speed - without operating the steering.
scientia non olet · About LEMON Manuals