Removing And Installing Starting Switch: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.

Move ignition switch to position 0 (same position as lock barrel).
Insert ignition switch into the housing. Tighten fastening screws using special tool 9263 and subsequently secure with screw locking paint.

Fig 1: Identifying Special Service Tool (9631)
Courtesy of PORSCHE OF NORTH AMERICA, INC.
Push plug onto ignition switch and fit air duct.
Connect battery ground cable. Perform function test.