LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Brakes, Mechanical) >> Removing And Installing The Rear Brake Disc >> Installation

Removing And Installing The Rear Brake Disc: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the levelling and centering surface on the brake disc and wheel hub. Then, apply a very thin coat of Optimoly TA to the centering surface on the wheel hub.
  2. Fit the brake disc.
    NOTE:
    • The right and left brake discs are the same part.
  3. Adjust the parking brake shoes and the parking brake cables (ADJUSTING PARKING BRAKE SHOES  ). Fit the brake caliper. Tighten the new screws of the brake caliper with 85 Nm (63 ft lb.) Ensure that the brake hose and brake line are in a perfect position.
NOTE: Replace the brake caliper fastening screws after every removal.
scientia non olet · About LEMON Manuals