LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2003 >> 911 Carrera 4S, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Brakes, Mechanical) >> Removing And Installing The Front Brake Disc >> Installation

Removing And Installing The Front Brake Disc: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 Porsche Boxster, 2003 Porsche Boxster, 2002 Porsche Boxster, 2001 Porsche Boxster, and 2000 Porsche Boxster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that all parts are in perfect condition and replace them if necessary.
  2. Clean the levelling and centering surface on the brake disc and wheel hub. Then apply a very thin coating of Optimoly TA to the centering surface on the wheel hub.
  3. Fit the brake disc.
  4. Fit the brake caliper. Tighten the new bolts of the brake caliper with 85 Nm (63 ft lb.). Ensure that the brake hose and brake line are in a perfect position.
NOTE: Replace the brake caliper fastening screws after each removal.
scientia non olet · About LEMON Manuals